Pedrollo ZX Vortex Submersible Dirty Water Pump

Description

Pedrollo ZX Vortex Submersible Dirty Water Pump

INSTALLATION & USE

The Pedrollo ZX-VORTEX Dirty Water Pump series are suitable for use with dirty water. They are are suitable for draining waste water in domestic applications and for pumping dirty water containing suspended solids up to Ø 40 mm. They distinguish themselves for the ease with which they are installed and their reliability under automatic operating conditions in fixed installations.

Typical Applications

A Dirty Water Pump is used for removing water that is likely to contain some solid particles. Typical examples of dirty water would include flood water, muddy water, pond water, emptying tanks, home waste water which is not filthy etc. Take care to note the maximum solids the pump can deal with to make sure you make the right selection.

CONSTRUCTION

Models: Pedrollo ZXm1A/40 | ZXm1B/40
Pump Body: Stainless steel AISI 304 with threaded port in compliance with ISO 228/1
Suction Filter: Stainless steel AISI 304
Diffuser: Stainless steel AISI 304
Impeller: Stainless steel AISI 304 VORTEX type
Motor Casing: Stainless steel AISI 304
Motor Casing Plate: Stainless Steel AISI 304
Motor Shaft: Stainless steel EN 10088-3 – 1.4104
Power Supply: 230V Single Phase (230/1/50)
Port: 1’1/2″
The pumps are complete with:
– 5 m long power cable
– float switch for single-phase versions

Hose Connection: ø 50mm

PERFORMANCE RANGE

Flow rate up to  400 l/min (24 m³/h)
Head up to 11m

APPLICATION LIMITS

Immersion Depth: 5m (with a sufficiently long power cable)
Maximum liquid temperature: +40 °C (maximum liquid temperature +90 °C for a maximum of 3 minutes of intermittent service)
Passage of suspended solids up to ø 40mm
Suction level down to 50 mm above ground level
240mm minimum immersion depth for continuous service S1