APLOS Clear Water2 in 1 Drinking Water Filter

Description

APLOS Clear Water2 in 1 Drinking Water Filter

APLOS Clear Water gives you fabulously fresh, natural tasting drinking water, free from harmful, toxic, poisonous impurities.

Less than 10 minutes to fit and instantly delivers drastically improved drinking water.

What does it remove?

Dirt
Rust
Silt
Chlorine
Pesticides
Herbicides
VOC’s
Heavy metals such as Lead
Forever chemicals inc PFOA
Trace pharmaceuticals
Parasites such as Giardia and Cryptosporidium
Some larger bacteria
Microplastics

The tech:

Premium water2 in 1 cleansing filter

Water is passed initially through a 5-micron sediment stage which will remove particles and impurities, extending the overall efficiency and longevity of the final stage.

In the final stage of purification the water is passed through an Activated Carbon block which removes the remaining contaminants, leaving you water Aplos Clear!

Technical Data:

– Working pressure range: 2 – 6 bar – Water flow rate: 5.6 l/min @ 4 bar – Max. temperature: 38°C – Min. temperature: 4°c

Product Safety Notices: – Designed for use with cold water supply only. – Avoid using the system with water that is microbiologically unsafe or of unknown quality unless it has been properly disinfected. – Do not use this system on water containing hardness greater than 50 mg/L without pre-treatment to remove hardness – If the filter is idle for more than 2 weeks, clean the filter inside and replace the cartridge.

Filter Lifespan:

– The filter has a capacity of 6000 litres (around 400 bath tubs!), and recommended replacement is every 6 months. – (Please note this will vary according to water usage and feed quality)

Filter Replacement Steps:

1. Shut off water supply to unit using the water isolation valve.
2. Run tap to remove any excess water.
3. Twist the housing anti-clockwise.
4. Using wrench to unscrew the housing body.
5. Take out the old cartridge and load with the new one, then install back in the same way.
6. Turn on the water supply to unit using the water isolation valve.
7. Flush filter for 5 minutes before using the filtered water.
8. Turn off the tap after 5 minutes and check for any leaks or drips via the in and out ports of the filter housing.
9. If you notice any dripping, make sure that tubes are inserted to the limit of the push-fit connection.