Easypress Pump Controller 110V

Description

DG Flow – Easypress Electric Pump Controller 110v

INSTALLATION & USE

The Easypress 110v pressure sensing pump controller automatically starts and stops the pump,

It is a substitute for traditional pressure switch/surge tank systems while offering important advantages.

NB Please ensure your power supply cable is large enough and as short as possible to ensure sufficient voltage reaches the controller.

KEY FEATURES

– Water Accumulator – Built-in
– Non-Return Valve – Built in
– 3 Piece Union – Integrated
– IP65 – Enclosure
– Resin protected PCB
– Free Positioning – Vertical, Horizontal or any angle
– Excessively Frequent Starts – Protection with auto reset
– Dry Run – Protection with auto reset

3 Piece Union – integrated – Avoiding the need of expensive 3 piece unions
Non-Return Valve – built-in and with easy inspection – Avoid the need to install one
Pressure Gauge – integrated

Pump Matching Essential Check

Carefully check the electric and hydraulic features and make sure they comply with those of the pump and the system, but in particular:

Easypress 1.5 bars start pressure requires:
– pump head of at least 2.5 bars &
– the water column between the device and the highest user point
must not exceed 15 mtrs – less 2 mtrs tolerance = 13 mtrs

TECHNICAL DETAILS:

Max Pump Power: 0.75Kw / 1Hp
Start Pressure: 1.5 bar
Max Current: 12A
Water Storage: Spring Membrane
Protections: Dry Run / Frequent Starts
Voltage: 110V
Frequency: 50/60Hz
Connections: 1″ BSP – MALE INLET – MALE OUTLET
Cut Off Flow Rate: 2 l/min
IP Protection: IP65