HydroForce Rainwater Harvesting Pump 800w

Description

HydroForce Rainwater Harvesting Pump 800w

INSTALLATION & USE

The HydroForce Series 3 is a high-quality pump for use under water or surface use in or with rainwater harvesting tanks. The Hydroforce Rainwater Harvesting pump is an electronically-controlled, pressure-sensitive, centrifugal roto-dynamic pump with no reciprocating parts.

The HydroForce Series 3 Rainwater Harvesting Pump features:
* Pressure-sensitive pump which turns itself off until there is a demand for water and a drop in pressure
* Max head (nominal) 35 meters
   pump pressure (nominal) at outlet 3.5 bar
   max suction 3 meters
* Dry-run Protection: when no water is detected for 8 seconds, the pump is turned off by the printed circuit board
* Alloy bulkhead, pressure release gap & twin chamber design prevents ingress of water to the motor, electrical components & to bearing oil
* Double bearing seal prevents egress of bearing oil
* Alloy bulkhead dissipates motor heat to water in the second chamber
* Logic processors in PCB prevent other pump anomalies and permit factory programming of reset timings

The pump and electrics are engineered to give a more reliable underwater performance.

Electricity consumption 800 watts at 220-240 Volts AC 50Hz (requires 10 or 13 amp fuse and RCD mains socket).
Connection cable 10m H07RN-F.

Inlet port 1 inch (25mm) female BSP. Output port 1 inch (25mm) female BSP provided with a push-fit connector for 1 inch (25mm) MDPE pipe.

PERFORMANCE RANGE

Flow rate up to  41 l/min (2.46 m³/h)
Head up to 35m

 

 

Additional information

Weight	14 kg
Dimensions	Length: 565 mm Width: 185 mm Height: 260 mm

Performance Data

Downloads

Hydroforce Brochure
HydroForce Installation Instructions